I thank ya people!
Mushroom, I don't think there is a small or tester kit as such for the decals i'm afraid.
Best you can do is go look at the site for the original outfit, they are based in the USA.
http://www.pulsarprofx.com/decalpro/ver ... rview.html
If you have none of the required equipment: colour laser printer, laminator, hot air gun etc then the first outlay is pretty expensive.
Along the lines of about £350 to £400 expensive.
Have to say on testing, it can do the job for certain and the learning curve is not too bad. Best on flatish surfaces and takes a try or two to get it going just the way you want it.
The top half of this page on my site should give you a better idea.
It's the second page on the next 1/350th Starship Enterprise Refit that this decal kit was specifically bought in for but is going to prove itself very useful to me in the future.
http://www.ianlawrencemodels.com/wipenterprise2.html
Hope the info helps a bit.
Raydrz, cheers mate!
As for doing another one, i'm afraid that barring cancellations, your're going to have to wait untill about the start of 2015 'fore I can take on anything new. Seriously packed out on the worklists and some fool decided there should only be 24hrs in a day, could do with 36 plus meself but that's just me
If however you want in on one then PM me and we'll yak about it.
Well the silliness goes on, super sculpey sodding about, baking balderdash and a squirt of grey primer gets the basis for the top of the forks. Handlbars to be added and cleaning up 'fore it goes under rubber to get a resin cast.
Good enough for a starter methinks so onward and more Hellhole happenings at a later date...honest!
Go easy out there all
)
and now I'm doing this 
. Guess you are all overawed with the eye-candy (or you've all turned uncharacteristically shy!) 
